Installation Instructions

www.fmiproducts.com
107540-01F
2
2. With cabinet door open, insert bottom pivot pin into
pivot plate located near bottom corner of front face
opening. Swing door to the vertical position, making
sure top pin slides into door track. Door is installed
when top door pin snaps into spring clip (see gur 5).
Please read Care and Operating Guidelines on page 1
before operating your appliance or replace.
Figure 4 - Replacing Door Stops on Various Models
CABINET GLASS DOORS
Door Installation
Cabinet type doors require a different type of door stop
than the standard factory-installed door stop basically de-
signed for bi-fold doors.
1. Remove old door stop by removing screws. Some
models may have old door stops fastened with rivets.
In this case, drilling will be required. Using new door
stop bracket as a template, measure and align to the
center of bottom front face and proceed to drill a 0.42''
diameter hole (see Figure 4). Install bracket with pro-
vided screws.
Figure 5 - Installing Glass Door
FULLY OPEN
CABINET TYPE DOORS
Figure 6 - Cabinet Doors Fully Opened
Use Door Stop
Bracket as
Template to Drill
Two 0.42'' dia.
Holes for Bullet
Retainers and
Two 0.124'' dia.
Pilot Holes for
Screws
Door Stop
Bracket
Bullet
Retainer
May Be
Adjusted
Bullet
Retainer
May Be
Adjusted
Use Door Stop
Bracket as
Template to Drill
Two 0.42'' dia.
Holes for Bullet
Retainers and
Two 0.124'' dia.
Pilot Holes for
Screws
Door Stop
Bracket
Pivot Plate
Spring Clip
Insert Pin into
Spring Clip
Insert Bottom
Pivot Pin into
Pivot Plate and
Swing Door
to the Vertical
Position
Side Top
Pin into
Door
Track