User's Guide

Temperature data logger LT2
User Guide
CUG00028-EN-A01
IJINUS - 25 ZA de Kervidanou 3, 29300 MELLAC – France : [phone] – Customer Service: [phone] / [e-mail]
7
4 Configuration of the logger using the software IJITempLab 4.7
4.1 Launch the software IJITempLab 4.7 and connect to the data logger to configure
After connection of the Wiji kit equipped with its antenna (or the Wiji key) on the laptop or PC USB port, run the
software IJITempLab.
NB: at least 1 meter distance is needed between the Wiji antenna and the datalogger for a correct radio
connection.
Click the “Connect” button so the software recognize the Wiji as a radio access point. If it doesn’t work you can
install the drivers from the top main menu, then Tools, and Install the Wiji driver :
Once connected you have to click the Refresh visible sensors” and choose from the list the available sensors
nearby :
The sensor or logger will be directly visible by its part number (SN) without the need to activate anything else
on the device. Locate the sensor's serial number (SN) on the sensor label (ex: IJT3005-00000398). You can click
Serial number of the desired sensor to start the configuration :