User's Manual
Table Of Contents
- I Contents
- II License Agreement
- III What's New in ARC System 2
- What's New in ARC System 2
- Chapter 1 ARC System 2 Overview
- Chapter 2 The ARC System 2 components
- Chapter 3 Setup for measurements
- Chapter 4 Using the ARC 2 Measurement
- 4.1 Opening the ARC 2 Measurement software
- 4.2 Welcome to the ARC System 2
- 4.3 STEP 1 - Microphone Selection
- 4.4 STEP 2 - Set up your Audio I/O
- 4.5 STEP 3 - Put the Measurement Microphone at the main position and adjust levels
- 4.5.1 Microphone orientation
- 4.5.2 Microphone height
- 4.6 STEP 4 - Take measurements
- 4.6.1 Examples of measurement locations in various room types
- 4.6.2 Take Measurements
- 4.7 STEP 5 - Save your system correction
- Chapter 5 Using the ARC 2 Plug-In
- 5.1 ARC 2 Plug-In interface
- 5.1.1 Play Window
- 5.1.2 Measurement menu
- 5.1.3 Target Curve menu
- 5.1.4 Virtual Monitoring Feature
- 5.1.5 Frequency Response Graphs
- 5.1.6 Speaker Icons
- 5.1.7 Peak Meter
- 5.1.8 Correction ON switch and TRIM knob
- 5.1.9 Other controls
- 5.2 Edit Window
- 5.2.1 EQ points
- 5.2.2 Custom 1-4 buttons
- 5.2.3 Apply button
- 5.2.4 Flat button
- 5.2.5 Combined L/R Correction
- 5.2.6 Full Range Bass Correction
- 5.3 Monitor Control Window
- 5.3.1 Main volume knob
- 5.3.2 Dim switch
- 5.3.3 Mute switch
- 5.3.4 Mode selector
- 5.3.5 MIDI Assign of Remote Controls
- 5.4 Opening the ARC 2 Plug-In in your DAW
- 5.5 Using the ARC 2 Plug-In
- 5.6 Suggestions for the best ARC System 2 usage
- Chapter 6 Frequently Asked Questions
- Chapter 7 Troubleshooting
- Chapter 8 Support
4 - Using the ARC 2 Measurement
2 8
ARC System 2
4.5.2 Microphone height
Set the microphone to the same height where your ears are when listening
to the speakers (figure 4.7).
figure 4.7
At this point, you should have your ARC 2 Measurement Microphone con-
nected to the audio interface mic input (+48 V phantom power ON), with the
aperture pointing toward ceiling, and at the correct height.
Now place the microphone at the main position (figure 4.8).
figure 4.8
Once the microphone is correctly positioned at the main position, you can
start checking levels.
1. Lower your studio listening volume to ZERO. The studio listening
volume can be controlled on your audio interface with the main
outputs level control or with your monitoring management system.