User's Manual
Table Of Contents
- I Contents
- II License Agreement
- III What's New in ARC System 2
- What's New in ARC System 2
- Chapter 1 ARC System 2 Overview
- Chapter 2 The ARC System 2 components
- Chapter 3 Setup for measurements
- Chapter 4 Using the ARC 2 Measurement
- 4.1 Opening the ARC 2 Measurement software
- 4.2 Welcome to the ARC System 2
- 4.3 STEP 1 - Microphone Selection
- 4.4 STEP 2 - Set up your Audio I/O
- 4.5 STEP 3 - Put the Measurement Microphone at the main position and adjust levels
- 4.5.1 Microphone orientation
- 4.5.2 Microphone height
- 4.6 STEP 4 - Take measurements
- 4.6.1 Examples of measurement locations in various room types
- 4.6.2 Take Measurements
- 4.7 STEP 5 - Save your system correction
- Chapter 5 Using the ARC 2 Plug-In
- 5.1 ARC 2 Plug-In interface
- 5.1.1 Play Window
- 5.1.2 Measurement menu
- 5.1.3 Target Curve menu
- 5.1.4 Virtual Monitoring Feature
- 5.1.5 Frequency Response Graphs
- 5.1.6 Speaker Icons
- 5.1.7 Peak Meter
- 5.1.8 Correction ON switch and TRIM knob
- 5.1.9 Other controls
- 5.2 Edit Window
- 5.2.1 EQ points
- 5.2.2 Custom 1-4 buttons
- 5.2.3 Apply button
- 5.2.4 Flat button
- 5.2.5 Combined L/R Correction
- 5.2.6 Full Range Bass Correction
- 5.3 Monitor Control Window
- 5.3.1 Main volume knob
- 5.3.2 Dim switch
- 5.3.3 Mute switch
- 5.3.4 Mode selector
- 5.3.5 MIDI Assign of Remote Controls
- 5.4 Opening the ARC 2 Plug-In in your DAW
- 5.5 Using the ARC 2 Plug-In
- 5.6 Suggestions for the best ARC System 2 usage
- Chapter 6 Frequently Asked Questions
- Chapter 7 Troubleshooting
- Chapter 8 Support
5 - Using the ARC 2 Plug-In
4 0
ARC System 2
5.1.2 Measurement menu
Click this menu (figure 5.2) to select the measurement set you saved from
the ARC 2 measurement system.
figure 5.2
ARC 2 is backward compatible with measurement files taken and used with
previous ARC System versions (ARC 1.3 minimum) and they will be listed
in the measurement menu below new ones; however, due to the different
and improved structure of the MultEQ
®
XT32 algorithm which powers the
correction, several features of ARC 2 will be unavailable when these older
measurement files will be loaded; this will be showed by the name of the
measurement highlighted in a red color once selected (fig. 5.3).
figure 5.3