User Manual

English
10
7. Turn your audio playback system on (Mixing console, Audio interface, etc.). Make sure you have set the
proper input sensitivity using the SENS button, then set the volume control to MAX (full clockwise). This
is the reference position for the SPL calibrated values in the specs. Adjust the volume control to a lower
position only if needed or only in case you require different levels between the speakers.
8. If needed, adjust the speaker response with the dedicated controls on the rear panel.
9. You can perform a speaker calibration to perfectly fit your iLoud MTM into your acoustic environment (for
more information refer to the dedicated paragraph in this manual).
10. It is possible to place the iLoud MTM horizontally using the supplied TPU support, however consider this as
a second option because the performance of iLoud MTM is specifically optimized to better work with the
acoustic environment when placed vertically. iLoud MTM has a controlled vertical dispersion that will make
the sweet-spot on the horizontal axis to be quite narrow when placed horizontally.
Note: Before plugging in and turning on, remember the “last on, first off” rule of powered speakers. When
powering up your system, be sure that all the wires are connected, turn on your mixer/interface and any other
outboard gear, and then lastly turn on your iLoud MTM. When powering down, turn your iLoud MTM off first and
then your mixer/interface and outboard gear.