User's Manual

English
11
Control panel
Audio inputs
Combo XLR-1/4” balanced line input
This combo connector allows for the connection of an analog audio source (i.e., mixer/audio interface bal/unbal
lineout).ConnectprofessionalequipmentwithbalancedoutputstotheXLRor1⁄4”TRSinputofthespeaker
using balanced signal cables.
Sensitivity +4dBu/-10dBV
The +4dBu / -10dBV input sensitivity button allows connection of the speakers to high-output professional
equipment without risk of input overload. It is possible to cycle between +4dBu and -10dBV by holding the
SENS button for more than 2 seconds. The level is set to the +4dBu level when it ships from our factory. This
setting will be best for most professional applications.
When connecting iLoud MTM to consumer equipment (as for example Hi-Fi components, smartphones, tablets,
Laptop computers and so on), set the level to the -10dBV setting. To determine the nominal output level of the
connected equipment, consult the documentation supplied with the connected equipment.
ARC Mic input
Use this 1/8” TS jack to connect the (included) ARC microphone that will allow you to perform a custom
calibration of the speaker to perfectly fit your environment.
Volume
This control allows you to adjust the input level of the audio source from -12dB to 0dB.
USB port
This USB type-B port is only used for service purposes, such as Firmware updates or factory checks.
Power
Power button: this pushbutton allows you to power on and off your iLoud MTM.
Power AC: connect the (included) power cord to this AC socket.
IMPORTANT: before attempting to connect/disconnect the power cord, make sure that the power button is set
to Off.