User's Manual

English
21
Troubleshooting
I have connected my device to iLoud MTM but no sound comes out.
Make sure to set up the volume with the volume control on iLoud MTM and/or with your device’s volume
control.
Sound is distorted.
When noticeable distortion occurs, please turn down the level of the speakers, or of the connected audio
source.
Calibration ended unsuccessfully (front LED blinks red)
If the calibration ends unsuccessfully and the front LED blinks red, make sure you have correctly inserted the
XLR cable both on the microphone and on the 1/8” ARC mic input on the rear of iLoud MTM.
Specifications
- Type: 2-Way/3-speakers bi-amped, digitally controlled studio monitor
- LF drivers: 2 x 3.5” polypropylene custom-made mid-woofers
- HD drivers: 1” low distortion, back chambered silk dome tweeter
- Acoustic design: DSP tuned bass reflex
- Number of amps per speaker: 2
- Amplifiers type: High efficiency Class-D
- Total power: 100W RMS
- LF power: 70W RMS
- HF power: 30W RMS
- Crossover type: Linear Phase Variable Order
- Crossover frequency: 3.1kHz
- Frequency response: from 50 Hz to 24 kHz +/- 2dB (40 Hz -6dB when uncal, -3 dB when cal)
- Phase response: System remains coherent within +/- 15° from 200Hz to 20kHz
- Sensitivity at +4dBu: 0dBu signal generates a 100 dB SPL @ 1 m
- Sensitivity at -10dBV: -11dBu signal generates a 100 dB SPL @ 1 m
- Maximum SPL @ 1m, one speaker playing, on axis: 103dB from 200Hz up sine wave, 95dB at 100Hz sine,
93dB pink noise
- Placement setup: Manual switches for LF Extension, LF trim, HF trim, Desk position
- LF extension switch: Sets -3dB point of the frequency response at 40, 50 or 60 Hz
- LF switch: Low shelf, +2dB or -3dB from 100Hz down
- HF switch: High shelf, +2dB or -2dB from 8kHz up
- Desk switch: -4dB at 160Hz and +1dB at 1.8kHz
- Calibration: Fully automatic and built-in digital calibration, microphone included
- Measurement microphone: Omnidirectional, Mems based precision measurement microphone
- Full DSP control