User's Manual

English

5. To abort the calibration press the FEEDBACK CANCEL button. iRig Acoustic Stage will return to the

previous state.

6. To return to the factory default calibration: start the calibration as per point (1) above then, while the

calibration process is going on, press the Tone button for at least 2 sec.

NOTE 1: the calibration process has a time out of “60” seconds. After this time the process automatically ends.

NOTE 2: the calibration can start only if the microphone is connected.

Phase switch

The phase flip switch (0°-180°) works pre-mix. When both the MEMS and the Piezo are connected the phase

switch acts on the MEMS signal. When only the MEMS is connected it act on the MEMS signal. When only the

Piezo is connected it act on the Piezo signal.