Guitar interface USER MANUAL
Contents Table of Contents Contents 2 English 3 iRig 2 3 Register your iRig 2 3 iRig 2 Overview 4 Installation and setup 5 Using iRig 2 with mixers, speakers or amplifiers 9 Amplifier output jack 9 THRU-FX switch 10 Setting input level 11 Stand adapter 11 Specifications 12 Warranty 12 Support and more info 12 2
English iRig 2 Thank you for purchasing iRig 2. Your package contains: • iRig 2 • Slot for velcro strip • Velcro strip • Quick start guide • Registration card 1x 1x 1x iRig 2 is the new and improved version of the groundbreaking and best selling iRig guitar interface. Featuring the powerful sound and streamlined convenience you loved about iRig, it packs essential new features like versatile gain control, a 1/4” amplifier output and Android compatibility into its sleek pocketable enclosure.
English iRig 2 Overview 6 2 5 4 1 3 1. Captive 1/8” TRRS cable 2. 1/4” TS amplifier output 3. THRU-FX switch 4. Input level control 5. 1/8” stereo headphone out 6.
English Installation and setup 1. Plug your iRig 2 into your device. 1/8" 2. Plug your headphones or earbuds into iRig 2.
English 3. Lower the volume of your device by using the volume buttons. 4. Put your headphones on. 1 2 5. Download and launch AmpliTube. AmpliTube ikdownloads.com/irig2 WARNING: Permanent hearing loss may occur if earbuds or headphones are used at high volume. You can adapt over time to a higher volume of sound, which may sound normal but can be damaging to your hearing. Set your device volume to a safe level before that happens.
English 6. Connect your guitar, bass or other mono instrument to the 1/4” TS input jack on iRig 2. 1/4" 7. Adjust the input level with the thumbwheel. NEVER turn the “NO FEEDBACK” option OFF in the AmpliTube app SETUP page when using headphones or earbuds, to avoid possible feedback. NEVER plug or unplug your headphones when AmpliTube is open and running.
English 8. Connect an external amplifier to the 1/4” TS Amplifier output jack on iRig 2 and select the behavior of this output via the THRU-FX switch. THRU 1/4" FX 9. If needed, connect the detachable velcro-slot to the back of iRig 2 and fix it to any stand or pole with the velcro strap.
English Using iRig 2 with mixers, speakers or amplifiers 1/8" 1/8" RCA 1/8" Amplifier output jack If needed you can connect an external amplifier to iRig 2. This is possible thanks to the “Amplifier output jack”, that allows you to send the processed signal (i.e. from a rig inside your mobile device) or a direct unprocessed signal, back out to an instrument amplifier or other unbalanced input.
English THRU-FX switch This switch allows you to select the type of output that is sent thru the “Amplifier output jack.” When this switch is set to THRU, the “Amplifier output jack” carries the same signal that is sent to the instrument input. This mode is typically used to send the instrument signal, that is plugged into the Instrument jack, back out to an instrument amplifier or other unbalanced input.
English Setting input level You can adjust the input level of your instrument via the dedicated thumbwheel. To increase the input level rotate the thumbwheel control toward the TRRS captive cable. To decrease the input level rotate the thumbwheel control toward the 1/4” instrument input jack. For the best sound, adjust the input level so that it’s as high as possible while still retaining a “clean” sound that’s not distorted or overloaded.
English Stand adapter You can fix iRig 2 to any microphone stand or pole via the included clip and velcro strip.
English Specifications - Instrument input: unbalanced, Hi-Z, TS 1/4” Jack, Tip: signal / Shield: ground - Instrument input impedance: 380 kOhms - Amplifier output: unbalanced, TS 1/4” Jack, Tip: signal / Shield: ground - Headphone output: 1/8” stereo headphone output - Frequency response: 20Hz-20kHz - Size (without cable): 72mm x 39mm x 21mm (2,83” x 1,53” x 0,82”) - Weight: 43g (0,0948lb) Warranty Please visit: www.ikmultimedia.com/warranty for the complete warranty policy. Support and more info www.
iRig® 2, AmpliTube®, iRig® Recorder, VocaLive®, SampleTank® are trademarks property of IK Multimedia Production Srl. iPad, iPhone, iPod touch, Retina and Mac are trademarks of Apple Inc., registered in the U.S. and other countries. iPad Air, iPad mini, and Lightning are trademarks of Apple Inc. All other trademarks are property of their respective owners.