SP209 Series 9-Channels, 200MSPS logic analyzer Product status: Active. 22.NOV.2018 ─ PRODUCT DATA SHEET (PRELIMINARY DATA) IKALOGIC S.A.S.
Ikalogic | SP209 series data sheet | 1 Table of contents Table of contents 1 SP209 Series overview 2 Typical applications 2 Product highlights 2 Main characteristics 3 SP209(i) Interfaces 3 Principle of operation 4 Embedded memory vs streaming 4 Versatile trigger system 4 External trigger OUT specifications 5 External trigger IN specifications 5 Industrial port (SP209i only) 5 What’s in the box 6 Unpacking and first usage 6 Status LEDs behavior 6 Software quick start guide 6
Ikalogic | SP209 series data sheet | 2 SP209 Series overview SP209 series logic analyzers and protocol decoders offer in depth analysis of logic signals and protocols with 200MHz (5ns) timing resolution. 9-channel operation allows 8-bit parallel data to be captured along with a clock or strobe signal. SP Series is composed of two devices, SP209 and SP209i. Both offer 9 logic inputs, but SP209i integrates industrial receivers for CAN, LIN, RS232 and RS485 buses1.
Ikalogic | SP209 series data sheet | 3 Main characteristics SP209(i) Interfaces Timing and measurements Sampling rate (MAX.) 200 MSPS External clock Max.
Ikalogic | SP209 series data sheet | 4 ● are later downloaded at a slower speed via the USB interface. This has the advantage of not being limited by USB transfer rate, but has the disadvantage of limited embedded memory. Streaming captured samples over the USB connection, at the maximum possible speed. While this offers the advantage of a virtually unlimited memory (only limited by host computer’s memory), it has the disadvantage of limiting the sampling rate to USB’s throughput.
Ikalogic | SP209 series data sheet | 5 off-the-shelf transceiver would receive if connected to that bus. External trigger IN specifications The list of the industrial inputs is detailed below: ● ● ● ● The Trig In port allows to start acquisition on an external event generated by another instrument. The minimum pulse width (T1) is 5ns. Polarity can be set in software. The input impedance is also software selectable (100kΩ or 50Ω). The threshold level is 1.0V.
Ikalogic | SP209 series data sheet | 6 What’s in the box CAN receiver specifications Max. baudrate 8 Mbps Common Mode Operating range ±12 V Common Mode Input Impedance T.B.D.
Ikalogic | SP209 series data sheet | 7 software and provided drivers. It is recommended to restart your computer after the software and drivers have been installed. Once the software is installed, run it, and create a new workspace by selecting “SP209” or “SP209i” as the device type.
Ikalogic | SP209 series data sheet | 8 or contact us for any inquiry at contact@ikalogic.com. Probes Probes cables are made of 24AWG extra flexible silicone wires. All wires are black colored, but every wire has a white marking tube with the channel number (e.g. “1” or “GND”) and a colored sticker on the probe tip.
Ikalogic | SP209 series data sheet | 9 Document Revisions ● ● 22-November-2018: ○ Fixed error in “What’s in the box” chapter ○ Updated trigger OUT and trigger IN specifications ○ Updated device weight 10-October-2018: Initial release of this datasheet. This information is subject to change without notice. © Ikalogic SAS 2018, www.ikalogic.
