20000003929 EUROSTAR_092014 IKA® EUROSTAR 200 digital Operating instructions EN Reg.-No.
3 2 C E D F 4 1 B Fig. 2 G J H K A L M G I Fig. 1 Fig. 3 Fig. 4 T U U S Q Fig. 5 G H Z G I W X V Fig. 6 Fig.
EN Source language: German Contents Page EC-Declaration of conformity 3 Explication of warning symbols 3 Safety instructions 4 Correct use 6 Unpacking 6 Drive 6 Motor protection 6 Speed – normal operation 6 Speed – overload operation 7 Output shaft 7 Speed display 7 Commissioning 7 Securing 8 Switching on the instrument 8 Maintenance and cleaning 9 Error codes 9 Warranty 10 Accessories 10 Permitted IKA® stirrer tools 10 Technical data 11 EC-Declaration of conformity We declare under our sol
Safety instructions • Read the operating instructions in full before starting up and follow the safety instructions. • Keep the operating instructions in a place where it can be accessed by everyone. • Ensure that only trained staff work with the instrument. • Follow the safety instructions, guidelines, occupational health and safety and accident prevention regulations.
DANGER DANGER DANGER DANGER DANGER The operation of a free rotating shaft end is dangerous. Therefore, for safety reason, only insert through the stirring tool over the upper edge of housing at standstill. Wear your personal protective equipment in accordance with the hazard category of the medium to be processed, otherwise there is a risk of: - splashing of liquids - projectile parts - body parts, hair, clothing and jewelry getting caught.
Correct use • Use For mixing/stirring liquids with low to high viscosities by various stirring tools. This instrument is suitable for use in all areas except: - Residential areas - Areas that are connected directly to a low-voltage supply network that also supplies residential areas.
Speed – overload operation The stirrer can deliver double output for a short time to even out load peaks which could occurs, for instance, if solid or semi-pourable agents are added. If the operation is in the overload range (e.g. process-related increase in viscosity), the actual speed is reduced until the stirrer torque corresponds to the nominal torque of the machine, and the target speed blinks.
Securing Securing the extension arm to the overhead stirrer Diagram (see Fig. 2) Ensure that the extension is fitted securely. Vibration may cause the screw to become loose. It is therefore necessary for safe use to occasionally check that the extension arm is attached securely. Tighten the hexangular bolt as if required. Securing the overhead stirrer to the stand Diagram (see Fig. 3) First secure the cross sleeve (H) to the stand (I).
Maintenance and cleaning The instrument is maintenance-free. It is only subject to the natural wear and tear of components and their statistical failure rate. Cleaning For cleaning disconnect the main plug! Use only cleaning agents which have been approved by IKA® to clean IKA® instruments.
Warranty In accordance with IKA® warranty conditions, the warranty period is 24 months. For claims under the warranty please contact your local dealer. You may also send the machine direct to our factory, enclosing the delivery invoice and giving reasons for the claim. You will be liable for freight costs.
Technical data Speed range I (high torque) Speed range II (high speed) Speed setting Speed display Speed setting accuracy Speed measurement deviation rpm Max. torque at stirrer shaft Ncm Max. stirring quantity (water) Max. viscosity Permitted on time Nominal voltage ltr mPas % VAC Frequence Max. input power Max. output power at stirring shaft Protection type acc.
IKA® - Werke GmbH & Co.KG Janke & Kunkel-Str. 10 D-79219 Staufen Tel. +49 7633 831-0 Fax +49 7633 831-98 sales@ika.de www.ika.