User guide
- 25 -
For example, in the basic setting with a measurement duration of 30 min. and a sampling time of 500
ms (two values per second) a total of 3,600 measured values result, which are saved during automatic
result recording.
Proceed as follows:
1. Open the dialog box by clicking on the
0HDVXULQJ6HWXS
menu command in the
"Measure" pulldown menu.
2. Enter the sampling time (in milliseconds).
3. Confirm the entry with
2.
1RWH
The setting range of the sampling time is 100 ms to 360,000 ms (6 min.).
Hints for setting the sampling time:
Longer sampling times
!PV
for long-term measurements over several hours.
Basic setting
PV
for typical measurement duration of approx. 30 minutes.
Short sampling times
PV
for measurement times of less than 30 minutes and for
measurement variables with a relatively high change speed.
0DQDJLQJVLJQDOIORZFKDUW
6HWWLQJSDUDPH WHUV
The functional units are configured with a special parameter windows in the form of dialog boxes.
Normally, all parameters required for a specific application can be set from here.
Dialog boxes of the result units (green) and arithmetical units (yellow) contain specific parameter sets
with which versatile evaluation and display possibilities can be configured; for example, these also
include multi-channel operating modes.
,PS RUW DQW
6HWWLQJFKDQQHOQXPEHUXSSH U DUURZEXWWRQV
Proceed as follows:
x
Press "arrow right" button repeatedly to increase (increment) the number of channels
(starting with 1). By pressing repeatedly, the number of channels can be set between 1 and
8. The number between the arrow buttons indicates the current number of channels.
x
Press "arrow left" button to decrease (decrement) the number of channels.
/DEHOOLQJFKDQQHOVORZHUDUURZEXWWRQV
Proceed as follows:
1. Select the first channel by pressing the arrow buttons. The number between the arrow
buttons indicates the current channel number.
2. Enter the description of the selected channel in the text field below (e.g. Curve 2).
3. Select the next higher channel by pressing the "arrow right" button or the next lower
channel by pressing the "arrow left" button.
4. Enter the description of the selected channel in the text field below.