User Manual-BZ 2000

ManualsBrandsikan ManualsCamcorder & Camera PeripheralsBlitz 2000 Pro Wireless 3G-SDI/HDMI Transmitter and Receiver Kit

BZ2000-ANT

High Gain Panel Antenna for Blitz 2000

1 x Panel Antenna

1 x Receiver Mounting Bracket

1 x Stand Mount Bracket

1 x Stand Mount Brace

5 x NJWC to SMA Coaxial Cable Connectors

4 x M3 Mounting Screws

4 x M4 Mounting Screws

www.ikancorp.com 713.272.8822

Summary of content (10 pages)

PAGE 1
BZ2000-ANT High Gain Panel Antenna for Blitz 2000 1x 1x 1x 1x 5x 4x 4x Panel Antenna Receiver Mounting Bracket Stand Mount Bracket Stand Mount Brace NJWC to SMA Coaxial Cable Connectors M3 Mounting Screws M4 Mounting Screws www.ikancorp.com support@ikancorp.com 713.272.8822 © 2015 ikan Corporation.
PAGE 2
PAGE 3
1 Product Description The Blitz BZ2000-ANT is a directional high-gain antenna compatible with the Blitz BZ1000 receiver. The five antenna ports connect to the panel antenna which can increase the maximum distance from 1000 ft to 2000 ft under the same conditions. This panel antenna will increase distance as well as signal strength for shorter distances. Follow these instructions carefully for best performance. If the product is not used correctly, you may experience poor results.
PAGE 4
2 Performance Parameters Specifications Model BZ2000-ANT Frequency Range 5.0-5.9GHz Gain 14±0.5dBi (F/B Ratio) ≥25dB Isolation ≥26dB Horizontal Beam Width 40±5º Vertical Beam Width 40±5º V.S.W.R ≤2.0 Polarization 5 ports: 3 ports vertical,2 ports±45º Maximum Power 100W Impedance 50ohm Working Temperature -40°C to + 55°C Connector Type 5*N-K Lightning Protection DC-Ground Installation Method Bracket Physical Speciﬁcation 2 Antenna Dimension 12 x 12 x 0.9 in.
PAGE 5
3 Packing List 1 x Panel Antenna 5 x NJWC to SMA coaxial cable connectors 1 x Receiver Mounting Bracket 4 x M3 Mounting Screws 1 x Stand Mount Brace 4 x M4 Mounting Screws 3
PAGE 6
4 Installation Guide 3 2 1 4 5 4
PAGE 7
4 Installation Guide 1 Install the stand mount brace to the receiver mounting bracket using the 4pcs M3*8 screws. 2 Place the BZ1000 receiver on the receiver bracket and line up the 4 holes from the Ikan Quick Mount system on the front of the unit to the 4 holes on the receiver bracket. Use the included 4 x M4 screws to then attach the receiver to the bracket.
PAGE 8
5 Installation Diagram Top view 45° Transmitter Receiver Side view TX & RX Must Face Each Other The receiver should be at least 2 meters off the ground.
PAGE 9
6 Troubleshooting (1) If there is no video signal within 10 to 30 ft, then check the video input source and output. (2) If you experience poor video quality from 1000 to 2000 ft please check whether the transmitter and receiver are set up as outlined in this manual. If they are setup correctly, then check if the coaxial cables on the antenna are connected properly, damaged, or if the port is dirty. (3) If you experience image noise it may be due to wireless interference.
PAGE 10
www.ikancorp.