User Manual

Starting the gimbal in default profile

• Press the power button for two solid seconds to power the gimbal on.

• The gimbal starts in Pan follow mode. (Profile 2)

• Use the five-way joystick (Fig. 9 [1]) to control the camera tilt and pan direction.

Push the joystick up or down for tilt up and down.

Push the joystick to the left or to the right to pan the camera left or right.

The OLED shows the current condition.

Switching the gimbal to different modes of operation (profiles)

• Press the mode button one time, which is located under the OLED screen to enter Lock Mode (Profile 1):

the camera will hold the direction and not follow, pan, or tilt.

• Press the mode button twice to enter Pan-Follow Mode (Profile 2): The gimbal follows pan and holds the

tilt position.

• Press the mode button three times to enter Follow Mode (Profile 3): The camera follows the tilt and pan

directions.

• Press the mode button four times to enter Full Follow Mode (Profile 4): The gimbal will follow roll, pitch,

and pan.

• Press the mode button five times to enter 60 Second Auto Sweep Mode (Profile 5): This will start a 60

second sweep of the camera from the end point back to the starting point.

• Press the mode button and hold for six seconds to calibrate the gyroscope.

Power ON ▲

Modes of Operation (Profiles) ▲