User Manual

STEP 2

Install the camera on gimbal base

• Install the camera with the quick release mounted into the Beholder DS2-A bottom mount base (Fig.5).

• Slightly adjust the position of the camera into the base until you find a horizontal balance.

• Shift the camera as close to the pitch motor as possible. Use the base plate positioning if needed.

• Tighten the thumb screws.

• Use a screwdriver to tighten the 1/4 quick release screw.

STEP 3

Adjust the gimbal roll – left and right balance

• Release the roll thumb M4 screw and make the arm the shortest. Then, tighten the M4 screw.

• Slide the roll arm left or right until the camera finds a balance position and doesn’t lean left or right.

• Tighten the thumb screws.