Quick start Guide

What’s in the box?
Installation & Power Supply
Please carry and place the packing box carefully. Check the lighting equipment and
accessories upon opening the box. Please contact us if anything is damaged or
missing. Please save the packing materials for replacing and repairing the products in
the future.
1. Ensure power is off before installation
2. Place the light on the Ikan customized stands, release the tension knob on the 5/8”
receiver, adjust the light in the desired direction, then tighten the tension knob on the
5/8” receiver.
3. When connecting the power cords, plug the AC power cords into the AC120 socket
on the rear panel (as shown in the drawing). If batteries are used a power, plug the
battery-powered wires into the DC12v socket. The battery voltage is 12v battery,
and the battery capacity should be determined by the battery run time, 12V 7Ah
battery may work for two hours approximately. It should be noted the light fixture
cannot be powered by both AC Power supply and DC Power Supply simultaneously,
otherwise the fixture may be damaged.
4. Illuminate light by pressing power switch. On the default screen (as shown below),
the number 13.8V at the upper right corner indicates the current internal DC Voltage.
When powered by the battery, it means the current battery voltage; however, this
number will display in flashing status if the voltage is lower than 11V which indicates
low battery voltage.
13.8V
100%
4500K