MPA70 QUICKSTART GUIDE 5-Section Lightweight Aluminum Monopod for Photo & Video What’s Included 1 x MPA70 Monopod 1 x Carrying Case 1 x 1/8" Hex Key www.ikancorp.com support@ikancorp.com CHECKED BY 713.272.8822 © 2017 ikan Corporation.
Ikan and all affiliated companies hereby disclaim any and all liabilities for property, equipment, building and electrical damages, injuries to any persons, and direct or indirect economic loss associated with the use or reliance of any information contained within this document, and/or as a result of the improper, unsafe, insufficient and negligent assembly, installation, rigging and operation of this product.
Introduction The MPA70 features a dual-sided mounting screw with a ¼-20 and 3/8-16 thread and 4 twist-lock knobs used to extend or contract the monopod height. How to Change Screw Thread The MPA70 comes pre-assembled with the dual-sided mounting screw set to 3/8-16. To flip the screw over to ¼-20 use the following steps: Step 1: To remove the circular base loosen the lock screw located next to the 3/8-16 screw.
Operating the Twist-Lock The MPA70 features 4 twist-lock knobs that divide the monopod into 5 sections. To adjust the height of the monopod, use the following steps: Step 1: While looking down at the monopod, grab the desired knob with your hand, and twist the knob clockwise to open it. Step 2: Adjust the height of the monopod by raising or lowering the open section.
Specifications Fixture Specifications Weight 1.59 lbs Minimum Height 18.8 in. Maximum Height 70.8 in. Leg Tube Diameter 0.87 - 1.35 in. Upper Disc Diameter 2.3 in. Vertical Payload Weight 35 lbs Horizontal Payload Weight 7 lbs Leg Sections Top Attachment 5 /8"-16 and ¼"-20 3 Leg Lock Type Twist Lock Material Aluminum * Do not exceed the payload weight when the monopod is extended out away from your body.
Learn More More dynamic information at official website: www.ikancorp.com Support Contact email: support@ikancorp.com CONDITIONS OF WARRANTY SERVICE • • Free service for one year from the day of purchase if the problem is caused by manufacturing errors. The components and maintenance service fee will be charged if the warranty period is expired. Free Service will not be Provided in the Following Situations:(*Even if the product is still within the warranty period.