Quick start Guide-MPA70

Introduction

The MPA70 features a dual-sided mounting screw with a ¼-20 and

-16 thread and 4 twist-lock knobs used to extend or

contract the monopod height.

How to Change Screw Thread

The MPA70 comes pre-assembled with the dual-sided mounting screw set to

-16. To ﬂip the screw over to ¼-20 use the

following steps:

Step 1: To remove the circular base loosen the lock screw located next to the

-16 screw. Use the provided

" hex key

and rotate the screw counter-clockwise just enough until it becomes loose.

Step 2: While looking down at the monopod, grab and twist the circular base in a counter-clockwise direction. Continue to

twist the base until it is detached from the monopod.

Step 3: Remove the mounting screw from inside the base, ﬂip over to the ¼-20 side, and reinsert the screw back into the

center of the base.

Step 4: Screw the circular base back on to the monopod by rotating it in a clockwise fashion. Firmly tighten the base with

your hand until secure.

Step 5: Finish securing the circular base to the monopod by tightening the lock screw with the provided

" hex key.