User's Manual

2 Hold the wireless dimmer close to the
light source you want to remove (no
more than 5 cm away).
3 Press and hold the pairing button
for at least 10 seconds, you can nd
the pairing button under the top cover.
A red light will shine steadily on the
wireless dimmer. Your light source will
begin to dim and ash twice to indicate
that it has been successfully un-paired.
FACTORY RESET YOUR DEVICES
For light sources:
Toggle the main switch 6 times.
For wireless dimmer:
Press the pairing button 4 times within
5 seconds.
SYNCHRONIZING
If your light source becomes
unsynchronized in brightness, dim up until
they all have reached 100% brightness.
If lights sources are unresponsive, press
the pairing button one time.
CHANGING THE BATTERY
When the wireless dimmer is used
regularly and as intended, the battery will
last for approximately 2 years.
When it’s time to replace the battery,
a red LED indicator will ash when you
rotate the wireless dimmer.
Open the top cover, remove the core and
replace the battery with a new CR2032
battery.
CAUTION!
Risk of explosion if battery is replaced
by an incorrect type. Dispose of used
batteries according to the instructions.
IMPORTANT!
The wireless dimmer is for indoor use only
and can be used in temperatures ranging
from 0ºC to 40 ºC.
Do not leave the wireless dimmer in direct
sunlight or near any heat source, as it may
overheat.
5