Users Manual

ADD LIGHT SOURCES TO YOUR STEERING DEVICE:
Before you can use your light source you’ll need to pair it
with a steering device.
To add more light sources, just repeat the steps below:
1. Make sure that your light source is installed and the main
power switch is turned on.
2. Hold the steering device close to the light source you
want to add (no more than 5 cm away).
3. Press and hold the pairing button for at least 10
seconds. A red light will shine steadily on the steering
device. Your light source will begin to dim and nally
ash one time to indicate that it has been successfully
paired.
Up to 10 light sources can be paired with 1 steering device.
Make sure to pair them one at a time. If the light sources
are close to each other, disconnect those that have already
been paired from the main power switch.
CAUTION:
DO NOT USE WITH STANDARD DIMMERS. Only use the
English 4