User Manual

7
Connecting to the Cylinder
• Conrmallbarbecuecontrolknobsareinthe
‘OFF’ position.
OFF
• Connect the regulator to the gas cylinder
according to the instructions below and the
instructions from the gas cylinder supplier.
Read carefully before use
Table (A)
COUNTRY INLET OUTLET
GB/IE Quick-on 27
HOSE NOZZLE
Ø8mm
Fig 1
4
1
3
2
Fig 2
Fig 3
OFF
ON
Fig 4
OFF
Operating and installation conditions
• The pressure regulator & hose kit is designed for
appliances with a service pressure of 37 mbar, as
indicatedonthepressureregulator(1),with
powerbelowthatindicatedontheregulator(1)
1.5kg/h of propane.
• The pressure regulator must be protected from
the rain in order to prevent water penetrating
throughthevent(3).
• To ensure correct system operation, make sure
thevent(3)isnotblockedbyobjectsor
materials.
• Do not move the cylinder during operation.
Fitting the regulator & hose kit
A) Fitting the operating appliance.
• Make sure all the taps of the operating appliance
are closed. Verify that hose inlet is correctly
connectedtobarbecueinlet(4).
B) Assembly on the gas cylinder
Make sure that:
• All taps of the consuming appliance are closed.
• The connecting pipe to the consuming appliance
iscorrectlytted.
• The “Compact Quick-on” regulator handle is in
the“o”position(Fig2).Removethesealcap
from the cylinder valve, place the “Compact
Quick-on”ontothevalveandpushdownrmly
and vertically. You should hear a “click” sound
which means the regulator is securely latched.
Notes: The “Compact Quick-on” is so designed
astopreventitfrombeingttedtothevalve,
unlesstheregulatorhandleisinthe“o”position;
therefore, never attempt to mount or to dismount
it, when the handle is not in that position.
C) Operation
OPEN (ON): Afterttingtheregulatorcorrectly
ontothevalve,gasowcanbeopenedbyturning
the regulator handle an anticlockwise half turn
tillthestopandtondtheoppositehorizontal
ONposition.InONpositionaredameandthe
marking “ON” is visible. In this position the valve is
openandthegascanow.
CLOSED(OFF): Thegasowcanbestoppedby
turning the knob clockwise half turn until the stop
and to reach the opposite horizontal OFF position.
In OFF position the valve is closed. No gas is
owing.
Caution: If you are unable to turn the regulator
handle to the “on” position, this means that
your “Compact Quick-on” is not correctly
connected to the valve. Do not force the handle
to open, and restart the operations described
under B) above.