User Manual

4English
HOW TO STEER YOUR LIGHTING
When the driver is connected to the mains, it is
possible to turn ON/OFF all products connected to
the driver, but if you want to dim or connect your
products to IKEA Smart lighting products, you need
to buy a separate steering device (e.g. a remote
control).
The steering device needs to be paired with your
driver/s. If you have more than one (1) driver you
can pair each one with the steering device, so that
the entire combination can be turned ON/OFF or
dimmed at the same time.
PAIRING A STEERING DEVICE TO YOUR DRIVER
1. Connect at least one (1) product to the driver
before you begin the pairing. Make sure that the
mains power is turned ON.
2. Locate the pairing symbol on the driver. Hold the
steering device close to the pairing symbol (no
more than 5 cm away).
3. Press and hold the pairing button on the steering
device for at least 10 seconds. A red light will
shine steadily on the steering device.
The product connected to the driver will begin to
dim and ash one time to indicate that the driver
is being paired to the steering device.
HOW TO FACTORY RESET YOUR DRIVER
If the driver does not respond or if you want to
un-pair the driver from a steering device you might
have to make a factory reset. The driver is forced to
factory reset by carefully push and hold the small
button (marked RESET) with a tip of pen on the
driver enclosure and applying a slight pressure. A
factory reset can also be done by toggle the main
switch 6 times.
IMPORTANT!
• The driver is for indoor use only and can be used
in temperatures ranging from 5ºC to 45 ºC.
• Do not leave the driver in direct sunlight or near
any heat source, as it may overheat.
• The declared radio range between the driver
and the steering device is measured in open air.
Dierent building materials and placement of the
units can aect the wireless connectivity range.
CARE INSTRUCTIONS
To clean the driver, wipe with a dry soft cloth.
Never use abrasive cleaners or chemical solvents as
this can damage the product.
PRODUCT SERVICING
Do not attempt to repair this product yourself, as
opening or removing covers may expose you to
dangerous voltage points or other risks.
Technical data:
Type:ICPSHC24-30-IL44-1
Input: 220-240 VAC, 50/60 Hz, 0.23A
Output: 24.0V DC
Max total load: 1.25 A, 30.0 W
Radio range: 10 m in open air.
Operatingfrequency:2400-2483.5 MHz
Output power: 14 dBm
DImension, mm: 220x65x26 mm
Weight: 233 gr
Typeoflightsource(s): LED
Eciencyinfull-load: 88 %
No-loadpowerconsumption(Pno): 0.24 W
Networkedstandbypower
consumption(Pnet):0.23 W
Standbypowerconsumption(Psb): N/A
Suitable as dimmer for light sources: Yes
Indooruseonly
Manufacturer: IKEA of Sweden AB
(commercial registration number: 556074-7551)
Address:Box702,SE-34381Älmhult,SWEDEN
The crossed-out wheeled bin symbol indicates that
the item should be disposed of separately from
household waste. The item should be handed in for
recycling in accordance with local environmental
regulations for waste disposal. By separating a
marked item from household waste, you will help
reduce the volume of waste sent to incinerators or
land-ll and minimize any potential negative impact
on human health and the environment. For more
information, please contact your IKEA store.