User Manual

10004076
Pre-tted
Low pressure
High pressure
Low pressure
Pre-tted
High pressure
10004076
7
English
Before use: Unscrew the Aerator/Flow Guide and
allow the water to run freely for a few minutes.
Then screw the Aerator/Flow Guide back in place.
Ensure that it is tight to prevent removal by hand.
English
Check at regular intervals to make sure that the
installation is not leaking.
English
To comply with UK water regulations, this
product shall be installed in accordance with the
following:
Inlet supply hoses shall be installed where light is
excluded.
Water supplies shall be at reasonably balanced
pressures from a common source (e.g. hot and
cold supplies both from the same storage or
both from a supply pipe). Where the tting is
supplied from unbalanced supplies (e.g. hot
and cold supplies from separate sources) an
‘Approved’ single check valve or some other no
less eective backow prevention device shall be
tted immediately upstream of both hot and cold
water inlets.