ÄLMAREN
English Installation must be performed in compliance with current local construction and plumbing regulations. If in doubt, contact a professional. English Switch off main shut-off valve before changing mixer tap.
110084 120172 120141 120142 120087 120143 2x 3
5 4 3 2 50 75 25 1 7 100 8 125 0 0 2 6 9 145 10 bar psi 0,5 - 5 bar 0,05 - 0,5 MPa 7,2 - 72.5 psi 0,2 - 10 bar 0,02 - 1 MPa 2,9 - 145 psi 60˚C 140˚F Max. 80˚C Max. 176˚F 139269 Pre-fitted High pressure 139268 Low pressure 10 5 4 3 2 25 1 0 0 60˚C 140˚F Max. 80˚C Max. 176˚F 50 75 2 6 7 100 125 145 bar psi 8 10 9 0,2 - 5 bar 0,02 - 0,5 MPa 2,9 - 72.
126908 G1/2 120172 120143 120141 120142 120087 1 360º 120º 8 5
1 English Seal the open surfaces with silicone to prevent water from penetrating the worktop upon any leaks. Silicone is not included.
2 2 Ø 34 - 37 mm Ø 1 3/8 - 1 1/2" Ø 34 - 37 mm Ø 1 3/8 - 1 1/2" 126908 65 Max. 2 9/16" Max.
360º 9 120º 360º 120º 110 08 8 4 AA-2258903-1
3 English IMPORTANT! Do not tighten too hard: this can damage hoses/pipes and washers.
English English To comply with UK water regulations, this product shall be installed in accordance with the following: Check at regular intervals to make sure that the installation is not leaking. Inlet supply hoses shall be installed where light is excluded. Water supplies shall be at reasonably balanced pressures from a common source (e.g. hot and cold supplies both from the same storage or both from a supply pipe). Where the fitting is supplied from unbalanced supplies (e.g.
© Inter IKEA Systems B.V.