Operation Manual

ENGLISH 17
Technical data
Data for test heating performance in accordance with IEC 60705.
The International Electrotechnical Commission has developed a standard for comparative
testing of heating performance of different microwave ovens. We recommend the following
for this oven:
Test Amount Approx. time Power level Container
12.3.1 Egg custard 750 g 11 - 12 min 650 W Pyrex 3.227
12.3.2 Sponge cake 475 g 9 min 650 W Pyrex 3.827
12.3.3 Meatloaf 900 g 16 - 18 min 800 W Pyrex 3.838
13.3 Meat defrost 500 g 14 min 160 W
NOTE: this information is only for the qualied technician.
Model identication: ANRÄTTA 704.117.67
Supply Voltage 230 V/50 Hz
Rated Power Input 2800 W
Fuse 10 A
MW output power 1000 W
Grill 800 W
Convection
Outer dimensions (HxWxD) 397 x 595 x 468
Cavity inner dimensions (HxWxD) 200 x 405 x 380
The technical informations are situated in the rating plate inside the appliance.
Mounting the appliance
Follow the supplied separate mounting
instructions when installing the appliance.
Installation and repairs must be carried out
by a qualied technician, in compliance
with the manufacturer’s instructions and
local safety regulations. Do not repair or
replace any part of the appliance unless
specically stated in the user manual.
Children should not perform installation
operations. Keep children away during
installation of the appliance. Keep the
packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of
children, during and after the installation of
the appliance.
Use protective gloves to perform all
unpacking and installation operations.
The appliance must be handled and
installed by two or more persons.
Installation
The appliance must be disconnected from
the power supply before carrying out any
installation operation.
After unpacking the appliance, make
sure that it has not been damaged during
transport. In the event of problems, contact
the dealer or your nearest After-sales
Service.
After unpacking the appliance, make sure
that the appliance door closes properly.
In the event of problems, contact the dealer
or your nearest After-sales Service. To
prevent any damage, only remove the oven
from its polystyrene foam base at the time
of installation.
During installation, make sure the
appliance does not damage the power
cable.