User Manual
5
ENGLISH
Product description
Control panel
"
Speed
Turns the motor on/o at speed one.
#
Speed
Turns the motor on at speed two / Activate charcoal lter
alarm.
Press and hold the button for approximately 2 seconds, with
all the loads turned o (Motor+Lights), to turn the Activated
Charcoal Filter alarm on. LED (A) ashes twice to conrm
To turn the alarm o, press the button again and hold for
at least 2 seconds.The relevant LED ashes once (A). Only for
recirculation mode.
$
Speed
Turns the Motor on at speed three / Reset alarm grease
lter saturation.
Press and hold the button for approximately 2 sec-
onds, with all the loads turned o (Motor+Lights), to
reset the grease lter saturation alarm. LED (A) ashes
three times.
%
Speed
Turns the motor on at Booster speed.
This speed is timed to run for 6 minutes. At the end of this
time, the system returns automatically to the speed that was
set before. If it is activated with the motor turned o, it will
switch to OFF at the end of the time. To deactivate it, press
button D or press button A.
&
Light
Press briey: Turns the lighting system on and o at
maximum intensity.
Press and hold to change the lighting intensity up or down.
S0614 (170201)
backlight symbols
112
20 20 20 20
8
S0614 (170201)
backlight symbols
"
#
$
%
&
Filters Alarm.
When the filter alarm is activated, the following messages
will appear over time:
Grease filter alarm must be cleaned: “A” key flashes once
per second.
Anti-odour filter alarm must be cleaned: “A” key flashes
twice per second.
Once the filters have been regenerated reset the alarm
signal.
Upper chimney
Lower chimney
Hood body
LED Lighting
Grease filter
Control panel