User manual

• It is advisable to wait at least four hours
before connecting the appliance to allow
the oil to flow back in the compressor.
• Adequate air circulation should be around
the appliance, lacking this leads to over-
heating. To achieve sufficient ventilation
follow the instructions relevant to installa-
tion.
• Wherever possible the back of the product
should be against a wall to avoid touching
or catching warm parts (compressor, con-
denser) to prevent possible burn.
• The appliance must not be located close to
radiators or cookers.
• Make sure that the mains plug is accessible
after the installation of the appliance.
Service
• Any electrical work required to do the
servicing of the appliance should be car-
ried out by a qualified electrician or com-
petent person.
• This product must be serviced by the After
Sales Service, and only genuine spare
parts must be used. The service numbers
are listed in the Service information.
Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The
appliance shall not be discarded together
with the urban refuse and rubbish. The insu-
lation foam contains flammable gases: the
appliance shall be disposed according to the
applicable regulations to obtain from your
local authorities. Avoid damaging the cooling
unit, especially at the rear near the heat ex-
changer. The materials used on this appli-
ance marked by the symbol
are recycla-
ble.
Control panel
1 2 3
1 Fan function switch
Fan light
2 Temperature regulator
Fast Freeze button
3 Fast Freeze indicator
Switching on
Warning! Remove, if present, the
removable label stuck on the inside of
the freezer compartment.
ENGLISH 6