User Manual

Products sold in GB only: Your product is
tted with an BS 1363/A approved electric
plug with internal fuse (ASTA approved to
BS 1362). If the plug is not suitable for
your socket outlets, it should be cut off
and an appropriate plug tted in its place
by an authorised customer service agent.
The replacement plug should have the
same fuse rating as the original plug. The
severed plug must be disposed of to avoid
a possible shock hazard and should never
be inserted into a mains socket elsewhere.
Products sold in AUS only: Use a residual
current device (RCD) with a rated residual
current of 30 mA or less.
VIBRATION INFORMATION
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given
in EN 62841. It may be used to compare
one tool with another and as a preliminary
assessment of exposure to vibration
when using the tool for the applications
mentioned in this manual. However, using
the tool for different applications, or with
different or poorly maintained accessories,
may signicantly increase the exposure
level.
An estimation of the level of exposure to
vibration should also take into account
the times when the tool is switched off or
when it is running but not actually doing
the job, as this may signicantly reduce
the exposure level over the total working
period.
Protect yourself against the effects of
vibration by maintaining the tool and its
accessories, keeping your hands warm,
and organising your work patterns.
ASSEMBLY
Before any work on the machine (e.g.
maintenance, tool change, etc) as
well as during transport and storage,
set rotational direction switch to the
centre position. Unintentional actuation
of the trigger can lead to injuries.
Charging your screwdriver
When the charger is connected to the
electricity supply, the red diode on the
screwdriver (Pic.2) (2.2) lights up. The
diode lights up while the battery is being
charged.
Under normal conditions of use the
screwdriver can be recharged several
hundred times.
ATTENTION! The recharging process
generates heat in the battery.
Note: The battery that is supplied with
the screwdriver has been charged for test
purposes only and must be fully recharged
before rst time use.
First read the safety instructions then
follow the loading instructions. Insert
the charging plug (Pic.2) (2.1) into the
charging socket in the screwdriver. Then
connect the charger to the electricity
supply.
Make sure that there are no knots or sharp
bends in the cable.
The charger and the battery have been
designed to be used together.
NEVER use this charger to recharge
cordless tools or batteries from other
manufacturers.
8