User Manual

The battery will gradually lose its charge
over a period of time, even if the tool is
not used.
The lithium-ion battery is protected against
deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is
empty, the machine is switched off by
means of a protective circuit: The tool no
longer rotates.
WARNING! Do not continue
to press the forward/reverse
switch after the machine has been
automatically switched off. The battery
can be damaged.
WARNING! Recharge the
batteryonanon-ammablesurface.
Do not recharge the battery for more
than eight hours. The red diode will
go out when the battery has been fully
loaded.
Disconnect the cable and store the charger
in a suitable place when it is not in use.
It is not advisable to recharge the battery
in temperatures below freezing.
INSTRUCTIONS FOR USE
Operation
This basic cordless screwdriver will accept
various types and length of screwdriver
bits that have a hexagonal shank that is
6.35mm (1/4") across the ats.
Inserting the screwdriver bits (Pic.3)
Select the correct screwdriver bit for the
screws being used. Insert the screwdriver
bit into the screwdriver drive, ensuring
that it is pushed rmly home.
Note: It is advisable to always drill a pilot
hole when driving screws with this product.
Switching ON and OFF (Pic.4)
The ON and OFF switch is of the "rocker
type" and also acts as the forward and
reverse switch. The forward and reverse
switch enables you to change the
direction of rotation to allow the removal
of screws. For screw driving squeeze
the trigger switch at the bottom (Pic.4)
(4.1). Releasing the switch will stop the
screwdriver. For screw removal squeeze
the switch in at the top (Pic.4)(4.2).
Spindle Auto-Lock
The tool´s spindle is automatically locked
when the tool is switched off. This enables
to use the screwdriver as a manual tool.
MAINTENANCE AND CLEANING
Before any work on the machine (e.g.
maintenance, tool change, etc) as
well as during transport and storage,
set the selector for rotation right/left
to the centre position. Unintentional
actuation of the trigger can lead to
injuries.
For safe and proper working, always
keep the machine and ventilation slots
clean.
9