Operation Manual

Problem Possible cause Solution
The door is not closed cor-
rectly.
Refer to "Closing the door".
The food products' tem-
perature is too high.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Many food products are
stored at the same time.
Store less food products at the
same time.
The thickness of the frost is
greater than 4-5 mm.
Defrost the appliance.
The door has been
opened often.
Open the door only if necessa-
ry.
If your appliance still is not
working properly after making
the above checks, contact the
After Sales Service. You can find
the list at the end of this manual.
Replacing the lamp
Caution! The appliance is
equipped with a longlife LED
interior light.
1. Disconnect the plug from the mains
socket.
2. Remove the screw from the lamp cover.
3. Press and push the lamp cover to
remove it.
4. Replace the lamp with a light of similar
characteristics and power.
No incandescent bulbs are
allowed. It is suggested to
use E14 LED light with
maximum 1,5 Watts.
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the plug to the mains socket.
8. Open the door.
Make sure that the light comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
the assembly instructions.
3. If necessary, replace the defective door
gaskets. Contact the After Sales Service.
ENGLISH 17