Operation Manual

ENGLISH 58
Before connecting the appliance, make sure
that:
the house electrical power supply 1.
nominal voltage matches that of the
appliance, as given on the rating plate;
the power supply line to which the 2.
appliance is connected is of adequate
power with respect to the max. power
absorbed by the appliance, as given on
the rating plate;
the house electrical system has a correct 3.
grounding system.
An omnipolar switch with a distance of •
at least 3 mm between contacts must be
installed.
NOTE: after installation, the electrical
components must only be accessible with
the use of a special tool.
The power cord must be of the H05RR-F
type, in compliance with the table given
below.
Power supply
voltage
Number of wires x
dimensions
1N ~ 230 V 3 x 1.5 mm
2
Instructions for the installer
Disconnect the power plug and close the •
gas tap before carrying out any repairs
or operation.
Thequaliedtechnicianisresponsible•
for the correct electrical and gas
installation according to current safety
regulations.
Grounding of the appliance is •
mandatory by law.
The Manufacturer declines any responsibility
for possible damage to persons, animals
or things due to non-compliance with the
above mentioned regulations. The technical
data is given on the rating plate located
on the back side of the appliance. The
adjustment conditions are given on a label
applied on the packing. Do not use the oven
door handle grip for handling operations,
or for removing the appliance from the
packing.
This appliance is in Class 1 (free standing
appliance).
Electrical connection