User manual

Problem Possible cause Solution
The appliance is noisy. The appliance is not installed
properly.
Check if the appliance stands
stable (all the feet should be on
the floor).
The appliance does not
operate. The Pilot light
does not flash.
The appliance is switched off. Switch on the appliance.
The mains plug is not connec-
ted to the mains socket cor-
rectly.
Connect the mains plug to the
mains socket correctly.
The appliance has no power.
There is no voltage in the
mains socket.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
The Pilot light flashes. The appliance is not working
properly.
Contact a qualified electrician.
The Alarm light flashes. The temperature in the freezer
is too high.
Refer to "Excessive Tempera-
ture Alarm"
The acoustic alarm
sounds
The temperature in the freezer
is too high.
Refer to "Excessive Tempera-
ture Alarm"
The compressor oper-
ates continually.
The temperature is not set cor-
rectly.
Set a higher temperature.
The door is not closed correct-
ly.
Refer to "Closing the door".
The door has been opened
too frequently.
Do not keep the door open lon-
ger than necessary.
The product temperature is
too high.
Let the product temperature
decrease to room temperature
before storage.
The room temperature is too
high.
Decrease the room tempera-
ture.
The Fast Freeze function is
switched on.
Refer to "Fast Freeze function".
The temperature in the
freezer is too low/high.
The temperature regulator is
not set correctly.
Set a higher/lower tempera-
ture.
If your appliance is still not working properly
after making the above checks, contact the
After Sales Centre. You can find the list at the
end of this manual.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to the
assembly instructions.
3. If necessary, replace the defective door
gaskets. Contact the After Sales Service.
ENGLISH 12