Instruction for Use
ENGLISH 8
WARNING:- Use safety gloves.
- Disconnect the appliance from the
power supply.
Never use steam cleaning equipment.- .
IMPORTANT: do not use corrosive or
abrasive detergents. If any of these products
accidentally comes into contact with the
appliance, clean immediately with a damp
cloth.
Clean the surfaces with a damp cloth. If it is
very dirty, add a few drops of washing up
detergent to the water. Finish off with a dry
cloth.
IMPORTANT: do not use abrasive sponges
or metallic scrapers or scourers. Over time,
these can ruin the surface.
Use detergents specically designed for
cleaning the appliance and follow the
manufacturer instructions.
Perimetersuctionpanel
The suction panel must be cleaned with the
same frequency as the grease lter. Use a
damp cloth and a soft liquid detergent.
Do not use products containing abrasives.
DO NOT USE ALCOHOL
The panel normally covers the grease lters,
and must therefore be opened each time
access to the grease lters and the inside
of the hood is required (e.g. to replace the
carbon lters).
Opening: Pull the panel (LEFT SIDE for 60
cm hood or FRONT SIDE for 80 cm hood)
downwards.
Closing: The panels must be xed to the
appropriate pins on the surface of the hood.
WARNING: Always check that the panel is
tted properly.
Tocleanthegreaselter
The metal grease lter has an unlimited life
and must be washed once a month by hand
or dishwasher at low temperature and with
a short cycle. With cleaning in a dishwasher
the grease lter may become dull; this does
not effect its ltering capacity.
Cleaningandmaintenance