Installation guide

3=
4=
Securely fasten oven to cabinet using the #8-14 x 1" screws
(2 screws provided). Insert the screws through holes in
mounting rails. Do not overtighten screws.
A
B
i :; ; ;'
A. Mounting rail
B. Insert #8-14 x 1" screw.
On some models, the oven vent is taped to the side of the
oven. See the following instructions to install.
• Insert the vent tabs (B) into slots (A) in the oven frame.
• With one #8-18 x 3/8"screw (C) for each side of the vent,
fasten vent securely to the oven.
C
A
B
D
Co np
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. For oven use and cleaning, read the Use and Care Guide.
Check Operation
1. Turn power on. "PF" should appear in the display. Turn the
selector knob to OFF and press OK button twice.
2. Turn knob selector to BAKE, "350F" will show on the display.
Press OK and look through the oven window. The top and
bottom elements should glow red.
If oven(s) does not operate, check the following:
• Household fuse is intact and tight; or circuit breaker has
not tripped.
• Electrical supply is connected.
• See "Troubleshooting" section in the Use and Care Guide.
3. When oven has been on for 5 minutes, feel for heat.
If you do not feel heat, turn off the oven and contact a
qualified technician.
4. Press CANCEL and turn knob selector to OFR
If you need Assistance or Service:
Please reference the "Assistance or Service" section of the Use
and Care Guide or contact the dealer from whom you purchased
your built-in oven.
A. Oven frame slot
B. Vent tab
C. #8-18 x 3/8" screw
D. Oven vent
5. Replace oven racks.
6. Replace oven door by inserting ends of hinges into hinge
slots in the oven frame.
7. Push hinges in as far as they will go and open the oven door.
You should feel the oven door drop into place.
8. Rotate both hinge latches back to the locked position.
9. Check that the door is free to open and close. If it is not,
repeat the removal and installation procedures.
10. Reconnect power.
11. Display panel will light briefly, and "PF" should appear in the
display.
12. If display panel does not light, please reference the
"Assistance or Service" section of the Use and Care Guide or
contact the dealer from whom you purchased your oven.
6