Operation Manual

ENGLISH 8
Tocleanthegreaselter
The metal grease lter has an unlimited life
and must be washed once a month by hand
or dishwasher at low temperature and with
a short cycle. With cleaning in a dishwasher
the grease lter may become dull; this does
not effect its ltering capacity.
Greaseltermaintenance:
1. Disconnect the hood from the electric
power supply.
2 Remove the grease lters: pull the spring
release handle downwards, then remove
the lter.
3. After cleaning the grease lter, remount
in reverse order ensuring the entire
extraction surface is covered.
Tocleanthewashablecharcoallter
The charcoal lter can be washed once
every two months using hot water and a
suitable detergent, or in a dishwasher at
65°C (if the dishwasher is used, select the
full cycle function and leave dishes out).
Eliminate excess water without damaging
the lter, then remove the mattress located
inside the plastic frame and put it in the
oven for 10 minutes at 100° C to dry
completely. Replace the mattress every 3
years and when the cloth is damaged.
Charcoalltermaintenance
1. Remove the grease lters.
2. Hook the charcoal lter at the back on
the metal tongue of the hood rst, then
on the front with the two knobs.
3. Reverse the above procedure to remove
the charcoal lter: by turning the knobs
xing it to the hood by 90°.
4. Ret the grease lters.
Lampmaintenance
Disconnect the hood from the electricity.
Warning
Prior to touching the light bulbs ensure they
are cooled down.
1. Use a small screwdriver or other suitable
tool to prise off the cover.
2. Snap-t the cover back on.
3. Use only max 12V-10W- G4 halogen
bulbs.
Important: make sure you don’t touch the
lamp with your bare hands.