LAGAN GB
ENGLISH 4
ENGLISH 4 Contents Safety instructions Product description Control panel Programmes Options Before first use Daily use 4 6 6 6 7 8 9 Hints and tips Care and cleaning Troubleshooting Technical information Environment concerns IKEA GUARANTEE 11 12 13 15 16 16 Subject to change without notice. Safety instructions Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages.
ENGLISH Electrical connection Warning! Risk of fire and electrical shock. • The appliance must be earthed. • Make sure that the electrical information on the rating plate agrees with the power supply. If not, contact an electrician. • Always use a correctly installed shockproof socket. • Do not use multi-plug adapters and extension cables. • Make sure not to cause damage to the mains plug and to the mains cable. Contact the service or an electrician to change a damaged mains cable.
ENGLISH 6 Product description 1 2 3 4 5 6 7 8 8 7 1 6 2 5 Lower spray arm Filters Rating plate Rinse aid dispenser Detergent dispenser Salt container Upper spray arm Upper basket 3 4 Control panel 2 1 3 4 1 On/off button 2 Programme indicators Indicators 3 Indicators 4 Program button Description Salt indicator. It is always off while the programme operates. End indicator.
ENGLISH 7 Programme Degree of soil 1) Type of load 3) Programme phases Duration (min) Energy (kWh) Water (l) Normal soil Crockery and cutlery Prewash Wash 65 °C Rinses Dry 100 - 110 1.2 - 1.6 15 - 16 Normal soil Crockery and cutlery Prewash Wash 50 °C Rinses Dry 195 1.02 15 1) The pressure and the temperature of the water , the variations of the mains supply, the options and the quantity of dishes can change the values.
ENGLISH 8 2. Press Program. The end indicator comes on. The acoustic signal for the end of programme is activated. 3. Press the on/off button to deactivate the appliance and to confirm the setting. Before first use 1. Make sure that the set level of the water softener agrees with the water hardness in your area. If not, adjust the water softener. Contact your local water authority to know the water hardness in your area. 2. Fill the salt container. 3. Fill the rinse aid dispenser. 4.
ENGLISH 9 5. Press the on/off button to deactivate the appliance and to confirm the setting. Filling the salt container Filling the rinse aid dispenser 1 2 3 4 Caution! Water and salt can come out from the salt container when you fill it. Risk of corrosion. To prevent this, after the replenishment, start a programme. 1 3 2 M 4 + AX - 5 Put 1 litre of water in the salt container (only for the first time). Put 1 kg of salt in the salt container.
ENGLISH 3. 4. 5. 6. 10 ance is in setting mode. Refer to ’SETTING AND STARTING A PROGRAMME’. • If the salt indicator is on, fill the salt container. Make sure that there is rinse aid in the rinse aid dispenser. Load the baskets. Add the detergent. Set and start the correct programme for the type of load and the degree of soil. Using the detergent 2 1 3 A A Put the detergent or the tablet in the compartment (A).
ENGLISH Opening the door while the appliance operates If you open the door, the appliance stops. When you close the door, the appliance continues from the point of interruption. Cancelling the programme 1. Open the appliance door. 2. Press and hold the programme button until all the programme indicators come on. Make sure that there is detergent in the detergent dispenser before you start a new programme. At the end of the programme The end indicator comes on. 1.
ENGLISH 12 • Combi detergent tablets contain detergent, rinse aid and other added agents. Be sure that these tablets are applicable to the water hardness in your area. Refer to the instructions on the packaging of the products. • Detergent tablets do not fully dissolve with short programmes. To prevent detergent residues on the tableware, we recommend that you use the tablets with long programmes. • Do not use more than the correct quantity of detergent.
ENGLISH 5 13 Cleaning the filter of inlet hose 6 D 1 2 A Remove filter (A). Wash the filter with water. Put filter (A) to its initial position. Make sure that it assembles correctly under the two guides (D). 7 8 Assemble filters (B) and (C). Put them into position in filter (A). Turn the handle clockwise until it locks. An incorrect position of the filters can cause bad washing results and damage to the appliance. B Close the water tap. Disconnect the hose.
ENGLISH 14 Alarm code Problem • The indicator of the set programme flash- The appliance does not fill with water. es continuously. • The end indicator flashes 1 time intermittently. • The indicator of the set programme flash- The appliance does not drain the water. es continuously. • The end indicator flashes 2 times intermittently. • The indicator of the set programme flash- The anti-flood device is on. es continuously. • The end indicator flashes 3 times intermittently.
ENGLISH 15 Problem Possible cause The salt indicator continues to stay on after the replenishment of the salt container. This can occur when you are If after 3 or 4 programmes, the using salt that needs more time salt indicator continues to stay to dissolve. on, contact the service. There is no unwanted effect on the performance of the appliance. After the checks are completed, activate the appliance. The programme continues from the point of interruption.
ENGLISH 16 Environment concerns Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office. • Discard correctly the packaging material. .
ENGLISH • Damage to the following parts: ceramic glass, accessories, crockery and cutlery baskets, feed and drainage pipes, seals, lamps and lamp covers, screens, knobs, casings and parts of casings. Unless such damages can be proved to have been caused by production faults. • Cases where no fault could be found during a technician’s visit. • Repairs not carried out by our appointed service providers and/or an authorized service contractual partner or where nonoriginal parts have been used.
ENGLISH Important! In order to provide You with a quicker service, we recommend that You use the specific phone numbers listed at the end of this manual. Always refer to the numbers listed in the booklet of the specific appliance You need an assistance for. Before calling us, assure that You have to hand the IKEA article number (8 digit code) for the appliance of which you need our assistance. Important! SAVE THE SALES RECEIPT! It is Your proof of purchase and required for the 18 guarantee to apply.
Country België Belgique Phone number 070 246016 Call Fee Opening time Binnenlandse gesprekskosten 8 tot 20 Weekdagen Tarif des appels nationaux 8 à 20. En semaine България 00359 888 16 0 8 Такса за повикване от страната От 9 до 18 ч в работни дни Česká republika 246 019721 Cena za místní hovor Danmark 70 15 09 09 Landstakst 8 až 20 v pracovních dnech man.-fre. 09.00-20.00 lør. 09.00-16.00 1 søndag pr.
156971280-A-392013 © Inter IKEA Systems B.V.
