User Manual
ENGLISH 6
ADD LIGHT SOURCES TO YOUR
STEERING DEVICE:
Before you can use your light source you’ll
need to pair it with a steering device.
To add more light sources, just repeat the
steps below:
1 Make sure that your light source is
installed and the main power switch is
turned on.
2 Hold the steering device close to the
light source you want to add (no more
than 5 cm away).
3 Press and hold the pairing button for
at least 10 seconds. A red light will shine
steadily on the steering device. Your light
source will begin to dim and nally ash
one time to indicate that it has been
successfully paired.
Up to 10 light sources can be paired with 1
steering device.
Make sure to pair them one at a time. If
the light sources are close to each other,
disconnect those that have already been
paired from the main power switch.
CAUTION:
DO NOT USE WITH STANDARD DIMMERS.
Only use the control provided with or
specied by these instructions to control
this bulb. This bulb will not operate
properly when connected to a standard
(incandescent) dimmer or dimming control.
Only controllable by IKEA Smart lighting
products.