LILLSVAN
Installation must be performed in compliance with current local construction and plumbing regulations. If in doubt, contact a professional. 2 Switch off main shut-off valve before changing mixer tap.
120143 1x 120141 120142 1x 110084 120172 2x 1x 1x 1x 3
1x 4 G1/2 120172 120143 126908 120141 120142 1 AA-2245852-1
1 4 5 6 7 3 8 2 1 0 60˚C Max. 80˚C 9 bar psi 10 0,5 - 5 bar 0,2 - 10 bar 124607 Pre-fitted High pressure 139268 Low pressure 9 1 4 5 6 7 3 8 2 1 0 60˚C Max.
2 1 120142 50 mm max. 2" max.
3 7
IMPORTANT! Do not tighten too hard: this can damage hoses/pipes and washers.
Before use: Unscrew the Aerator/Flow Guide with a coin and allow the water to run freely for a few minutes. Then screw the Aerator/Flow Guide back in place up to the stop DO NOT OVER TIGHTEN. 124607 Pre-fitted High pressure 139268 Low pressure 10004080 Pre-fitted Low pressure 124607 High pressure Check at regular intervals to make sure that the installation is not leaking.
110084 Inlet supply hoses shall be installed where light is excluded. Water supplies shall be at reasonably balanced pressures from a common source (e.g. hot and cold supplies both from the same storage or both from a supply pipe). Where the fitting is supplied from unbalanced supplies (e.g. hot and cold supplies from separate sources) an ‘Approved’ single check valve or some other no less effective backflow prevention device shall be fitted immediately upstream of both hot and cold water inlets.
AA-2245852-1