User Manual

Problem and alarm code Possible cause and solution
Malfunction of the wash
pump or the drain pump.
The display shows i51 - i59 or
i5A - i5F.
• Switch the appliance o and on.
The temperature of the wa‐
ter inside the appliance is too
high or malfunction of the
temperature sensor occur‐
red.
The display shows i61 or i69.
• Make sure that the temperature of the inlet water does
not exceed 60°C.
• Switch the appliance o and on.
Technical malfunction of the
appliance.
The display shows iC0 or iC3.
• Switch the appliance o and on.
The level of water inside the
appliance is too high.
The display shows iF1.
• Switch the appliance o and on.
• Make sure that the lters are clean.
• Make sure that the outlet hose is installed at the right
height above the oor. Refer to the installation instruc‐
tions.
The appliance stops and
starts more times during op‐
eration.
• It is normal. It provides optimal cleaning results and ener‐
gy savings.
The programme lasts too
long.
• If the delay start option is set, cancel the delay setting or
wait for the end of the countdown.
• Activating options can increase the programme duration.
The remaining time in the
display increases and skips
nearly to the end of the pro‐
gramme duration.
• This is not a defect. The appliance is working correctly.
Small leak from the appli‐
ance door.
• The appliance is not levelled. Loosen or tighten the ad‐
justable feet (if applicable).
• The appliance door is not centred on the tub. Adjust the
rear foot (if applicable).
The appliance door is dicult
to close.
• The appliance is not levelled. Loosen or tighten the ad‐
justable feet (if applicable).
• Parts of the tableware are protruding from the baskets.
ENGLISH 26