User manual

Steam Cleaning
Remove the worst dirt manually.
1. Put 250 ml of water with 3 tablespoons
of vinegar directly into the steam
generator.
2. Activate the function: Steam Cleaning.
The display shows the duration of the
function. An acoustic signal sounds when
the programme is completed.
3. Touch any symbol to deactivate the
signal.
4. Wipe out the appliance with a soft cloth.
Remove the water from the steam
generator.
Keep the appliance door open for
approximately 1 hour. Wait until the
appliance is dry. To speed up the drying
you can heat up the appliance with hot air
at temperature 150 °C for approximately
15 minutes.
Steam generation system
Caution! Dry the steam
generator after each use.
Remove the water with the
sponge.
Remove the limescale with water
and vinegar.
Caution! Chemical de-scaling
agents can cause damage to the
enamel. Follow the instructions of
the manufacturer.
1. To clean the water drawer and the
steam generator, put the water and
vinegar mixture (approximately 250 ml)
through the water drawer into the steam
generator. Wait for approximately 10
minutes.
2. Remove the water and vinegar with the
sponge.
3. Put clean water (100 - 200 ml) into the
water drawer to flush the steam
generation system.
4. Remove the water from the steam
generator with the sponge and rub it
dry.
5. Keep the door open to let the appliance
dry fully.
Removing and installing the door
The oven door has three glass panels.You
can remove the oven door and the internal
glass panels to clean them.
The oven door can close if you
try to remove the glass panels
before you remove the oven
door.
Caution! Do not use the
appliance without the glass
panels.
1. Open the door fully.
2. Fully press the clamping levers (A) on
the two door hinges.
A
A
3. Close the oven door to the first opening
position (approximately 70° angle).
4. Hold the door with one hand on each
side and pull it away from the appliance
at an upwards angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface. This
is to prevent scratches.
6. Hold the door trim on the top edge of
the door at the two sides and push
inwards to release the clip seal.
ENGLISH
24