User manual

Acoustic signals
Acoustic signals sound when a malfunction
of the appliance occurs. It is not possible to
deactivate these acoustic signals.
There is also an acoustic signal that sounds
when the programme is completed. By
default, this acoustic signal is activated and
it is possible to deactivate it.
In addition, an acoustic signal will sound
before the AutoOpen will open the door.
This acoustic signal stops only if AutoOpen
is deactivated.
When pressing the main switch to turn on
the dishwasher, it makes a short beep
sound. The beep is activated by default, but
it is possible to deactivate it together with
the end of programme acoustic signal.
How to deactivate the acoustic signals
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
simultaneously
and until
the indicators , , and
flash and the display is blank.
2. Press .
• The indicators
, and
are off.
• The indicator still flashes.
• The display shows the current setting:
– = Acoustic signal off.
– = Acoustic signal on.
3. Press to change the setting.
4. Press on/off to confirm the setting.
AutoOpen
AutoOpen improves the drying results with
less energy consumption.
During the drying phase, the
door opens automatically and
remains ajar.
Caution! Do not try to close the
appliance door within 2 minutes
after automatic opening. This can
cause damage to the appliance.
AutoOpen is automatically activated with
all programmes excluding
.
To improve the drying performance refer to
the DryPlus option or activate AutoOpen.
To avoid possible hazards inside
the appliance (such as knives,
sharp objects or chemicals) for
children, pets or people with
disabilities deactivate the
function.
How to deactivate AutoOpen
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
simultaneously and until
the indicators
, , and
start flashing and the display is blank.
2. Press .
• The indicators , and
are off.
ENGLISH
12