User manual
Table Of Contents
- Contents
- Safety information
- Safety instructions
- Product description
- Control panel
- Programmes
- Options
- Settings
- Programme selection mode and user mode
- How to set the programme selection mode
- The water softener
- How to set the water softener level
- The rinse aid empty notification
- How to deactivate the rinse aid empty notification
- Acoustic signals
- How to deactivate the acoustic signals
- AutoOpen
- How to deactivate AutoOpen
- Before first use
- Daily use
- Hints and tips
- Care and cleaning
- Troubleshooting
- Technical information
- Inhaltsverzeichnis
- Sicherheitshinweise
- Sicherheitsanweisungen
- Gerätebeschreibung
- Bedienfeld
- Programme
- Optionen
- Einstellungen
- Vor der ersten Inbetriebnahme
- Täglicher Gebrauch
- Tipps und Hinweise
- Reinigung und Pflege
- Fehlersuche
- Technische Daten
Problem Possible cause and solution
There are whitish streaks or
bluish layers on glasses and
dishes.
• The release quantity of rinse aid is too much. Adjust
the rinse aid level to a lower level.
• The quantity of detergent is too much.
There are stains and dry wa-
ter drops on glasses and
dishes.
• The released quantity of rinse aid is not sufficient. Ad-
just the rinse aid level to a higher level.
• The quality of the rinse aid can be the cause.
The dishes are wet.
• For the best drying performance activate the option
DryPlus and set AutoOpen .
• The programme does not have a drying phase or has
a drying phase with low temperature.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
• The quality of the multi-tablets can be the cause. Try a
different brand or activate the rinse aid dispenser and
use rinse aid and multi-tablets together.
The interior of the appliance is
wet.
• This is not a defect of the appliance. it is caused by the
humidity in the air that condenses on the walls.
Unusual foam during washing.
• Use the detergent for dishwashers only.
• There is a leak in the rinse aid dispenser. Contact an
Authorised Service Centre.
Traces of rust on cutlery.
• There is too much salt in the water used for washing.
Refer to "The water softener".
• Silver and stainless steel cutlery were placed together.
Avoid to put silver and stainless steel items close to-
gether.
There are residues of deter-
gent in the dispenser at the
end of the programme.
• The detergent tablet got stuck in the dispenser and
therefore was not completely washed away by water.
• Water cannot wash away the detergent from the dis-
penser. Make sure that the spray arm is not blocked or
clogged.
• Make sure that items in the baskets do not impede the
lid of the detergent dispenser from opening.
Odours inside the appliance.
• Refer to "Internal cleaning".
ENGLISH 22