User manual

Cleaning the spray arms
Do not remove the spray arms. If the holes
in the spray arms are clogged, remove
remaining parts of soil with a thin pointed
object.
External cleaning
• Clean the appliance with a moist soft
cloth.
• Only use neutral detergents.
• Do not use abrasive products, abrasive
cleaning pads or solvents.
Internal cleaning
• Carefully clean the appliance, including
the rubber gasket of the door, with a soft
damp cloth.
• If you regularly use short duration
programmes, these can leave deposits of
grease and limescale inside the
appliance. To prevent this, we
recommend to run long duration
programmes at least 2 times per month.
• To maintain the performance of your
appliance at its best, we recommend to
use monthly a specific cleaning product
for dishwashers. Follow carefully the
instructions on the packaging of the
product.
Troubleshooting
If the appliance does not start or it stops
during operation. Before you contact an
Authorised Service Centre, check if you can
solve the problem by yourself with the help
of the information in the table.
With some problems, the display shows
an alarm code.
Problem and alarm code Possible solution
You cannot activate the ap-
pliance.
• Make sure that the mains plug is connected to the mains
socket.
• Make sure that there is no damaged fuse in the fuse box.
The programme does not
start.
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or wait for the
end of the countdown.
• The appliance has started the procedure to recharge the
resin inside the water softener. The duration of the pro-
cedure is approximately 5 minutes.
ENGLISH 18