User manual

Problem Possible cause Remedy
The display shows an error
code that is not in this table.
There is an electrical fault.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
an Authorised Service
Centre.
There is no good cooking
performance using the func-
tion: Direct Steam.
You did not turn on the func-
tion: Direct Steam.
Refer to "Activating the func-
tion: Direct Steam".
There is no good cooking
performance using the func-
tion: Direct Steam.
You did not fill the cavity
embossment with water.
Refer to "Activating the func-
tion: Direct Steam".
The water in the cavity em-
bossment does not boil.
The temperature is too low. Set the temperature at least
to 110 °C.
The water comes out of the
cavity embossment.
There is too much water in
the cavity embossment.
Deactivate the oven and
make sure that the appli-
ance is cold. Wipe the water
with a cloth or sponge. Add
the correct amount of water
to the cavity embossment.
Refer to the specific proce-
dure.
The lamp is turned off. The Eco Fan Cooking func-
tion is turned on.
Normal behaviour of the Eco
Fan Cooking function. Refer
to "Daily Use" chapter,
Heating Functions.
Service data
If you cannot find a solution to the problem
yourself, contact an Authorised Service
Centre.
The necessary data for the service centre is
on the rating plate. The rating plate is on
the front frame of the oven cavity. Do not
remove the rating plate from the oven
cavity.
ENGLISH 29