User manual

Problem Possible cause Solution
Water flows on the rear
plate of the refrigera-
tor.
During the automatic defrost-
ing process, frost defrosts on
the rear plate.
This is correct.
Water flows into the re-
frigerator.
The water outlet is clogged. Clean the water outlet.
Products prevent that water
flows into the water collector.
Make sure that products do
not touch the rear plate.
Water flows on the
ground.
The melting water outlet does
not flow in the evaporative
tray above the compressor.
Attach the melting water outlet
to the evaporative tray.
There is too much frost
and ice.
Food products are not wrap-
ped properly.
Wrap the food products bet-
ter.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The Temperature regulator
may be set incorrectly.
Set a higher temperature.
The temperature in the
appliance is too high.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The product temperature is
too high.
Let the product temperature
decrease to room temperature
before storage.
Many products are stored at
the same time.
Store less products at the
same time.
The temperature in the
refrigeration is too high.
There is no cold air circula-
tion in the appliance.
Make sure that there is cold
air circulation in the appliance.
The temperature in the
freezer is too high.
Food products are too near
to each other.
Store food products so that
there is cold air circulation.
The appliance does not
operate.
The appliance is switched off. Switch on the appliance.
The mains plug is not connec-
ted to the mains socket cor-
rectly.
Connect the mains plug to the
mains socket correctly.
The appliance has no power.
There is no voltage in the
mains socket.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
The lamp does not
work.
The lamp is in stand-by. Close and open the door.
ENGLISH 17