User Manual

• Change the spin speed. The display
shows only the spin speeds available for
the set programme.
• Set the No Spinspin options .
Set this option to deactivate all spin
phases. The appliance performs the only
draining phase of the selected washing
programme. Set this option for very
delicate fabrics. The rinses phase uses
more water for some washing
programmes
• Activate the Rinse Hold
option.
The nal spin is not performed. The water
of the last rinse is not drained out to
prevent the fabrics from creasing. The
washing programme ends with water in
the drum.
The indicator
is on display. The door
stays locked and the drum turns regularly
to reduce creasing. You must drain the
water to unlock the door.
If you touch the button
, the appliance
performs the spinning phase and drains
the water.
The appliance empties the
water out automatically after
18 hours approximately.
11
Temperature
When you select a washing programme, the
appliance automatically proposes a default
temperature. With this option you can
change the temperature.
The indicator
= cold water.
12
Thanks to this button, a cycle can perform:
• Only washing:
indicator is on (default
mode).
• Washing and drying: and
indicators are on.
• Only drying: indicator is on.
Acoustic signals
This appliance has dierent acoustic signals.
To activate/deactivate some of the acoustic
signals when the programme is completed,
touch the
and the buttons
simultaneously for about 2 seconds. The
display shows On or O.
Daily use
Warning! Read the safety
booklet.
Before the very rst use, pour 2
litres of water into the detergent
compartment marked by .
Pour 2 litres of water into the
detergent compartment marked
by . Pour a small quantity of
detergent into the compartment
marked by . Set and start a
programme for cotton at the
highest temperature without any
laundry in the drum. This
removes all possible dirt from the
drum and the tub.
1. Make sure that the mains plug is
connected to the mains socket.
2. Make sure that the water tap is open.
3. Load the laundry.
4. Pour the detergent and other treatments
in the proper compartment of the
detergent dispenser.
5. Push the button to switch the
appliance on.
6. Turn the programme dial to set the
desired programme.
The appliance defaults to the washing
only mode and the indicator of the
button is on.
If you wish to run a washing and drying
cycle, tap on the Mode button
once to activate also the drying function.
ENGLISH 12
To download the full version visit www.ikea.com