User Manual
Table Of Contents
- Contents
- Safety information
- Safety instructions
- Product description
- Technical data
- Inspection check list
- First use
- Control panel
- Programmes
- Settings
- Daily use
- Activating the appliance
- Loading the laundry
- Filling the detergent and additives
- Setting a programme
- Starting a programme
- Starting a programme with the delay start
- The AutoAdjust System load detection
- Pausing a programme and changing options
- Cancelling a running programme
- Opening the door
- End of the programme
- Draining water out after end of cycle
- Stand-by function
- Hints and tips
- Care and cleaning
- Troubleshooting
- Consumption values
Carefully close the
detergent dispenser
drawer.
Make sure that the
ap does not block
the drawer when
closing.
Setting a programme
1. Turn the programme knob to select the
desired washing programme.
The indicator of the Start/Pause
button
ashes.
The display shows an indicative programme
duration.
2. To change the temperature and/or the
spin speed, touch the related buttons.
3. If desired, set one or more options by
touching the related buttons. The related
indicators illuminate.
If a selection is not possible an
acoustic signal sounds and the
display shows
.
Starting a programme
Touch the Start/Pause button to start the
programme. The related indicator stops
ashing and stays on. It is not possible to
start the programme when the indicator of
the button is o and doesn't ash (e.g.
programme knob on a wrong position).
The programme starts, the door is locked.
The display shows the indicator
.
The drain pump can operate
shortly before the appliance lls
water.
Starting a programme with the delay
start
1. 1. Touch the Delay Start button
repeatedly until the display shows the
desired delay time. On the display the
indicator shows
2.
Touch the Start/Pause button. The
appliance door locks and starts the
countdown of the delay start. The display
shows the indicator .
When the countdown is completed, the
programme starts automatically.
Cancelling the delay start after the
countdown has started
To cancel the delay start:
1. Touch the Start/Pause button to
pause the appliance. The related
indicator ashes.
2. Touch the Delay Start
button
repeatedly until the display shows
and
the indicator goes o.
3. Touch the Start/Pause button again
to start the programme immediately.
Changing the delay start after the
countdown has started
To change the delay start:
1. Touch the Start/Pause button to
pause the appliance. The related
indicator ashes.
2. Touch the Delay Start
button
repeatedly until the display shows the
desired delay time.
3. Touch the Start/Pause
button again
to start the new countdown.
The AutoAdjust System load
detection
After touching the Start/Pause button:
1. The AutoAdjust System starts estimating
the weight of the load to calculate the
real programme duration. During this
phase the indicator
placed below
the time digits plays a simple animation.
2. After about 15-20 minutes the indicator
disappears and new cycle duration
is displayed.
ENGLISH
22