User Manual
Table Of Contents
- Contents
- Safety information
- Safety instructions
- Product description
- Technical data
- Inspection check list
- First use
- Control panel
- Programmes
- Settings
- Daily use
- Activating the appliance
- Loading the laundry
- Filling the detergent and additives
- Setting a programme
- Starting a programme
- Starting a programme with the delay start
- The AutoAdjust System load detection
- Pausing a programme and changing options
- Cancelling a running programme
- Opening the door
- End of the programme
- Draining water out after end of cycle
- Stand-by function
- Hints and tips
- Care and cleaning
- Troubleshooting
- Consumption values
softener and/or formation of mould.
Proceed as follows:
To remove the drawer, press the lever
downwards and pull it out.
To aid cleaning,
remove also the top
part of the additive
compartment.
Use a sti brush to
clean and remove all
washing powder
residue.
Flush out all the
removed parts of the
dispenser drawer
under a tap to remove
any traces of
accumulated powder.
Use the previous
brush to clean the
recess, ensuring that
upper and lower part
of it is well cleaned.
After having cleaned the dispenser and the
drawer recess, replace it and run a rinse
programme without any laundry in the drum
to ush away any residue.
Cleaning the drain pump
Warning! Disconnect the mains
plug from the mains socket.
Regularly check the drain pump
lter and make sure that it is
clean.
Clean the drain pump if:
• The appliance does not drain the water.
• The drum does not turn.
• The appliance makes an unusual noise
because of the blockage of the drain
pump.
• The display shows the alarm code
.
Warning!
• Do not remove the lter while
the appliance operates.
• Do not clean the pump if the
water in the appliance is hot.
Wait until the water cools
down
Proceed as follows to
clean the pump:
1. Open the pump
cover.
ENGLISH 28