User Manual
Table Of Contents
- Contents
- Safety information
- Safety instructions
- Product description
- Technical data
- Inspection check list
- First use
- Control panel
- Programmes
- Settings
- Daily use
- Activating the appliance
- Loading the laundry
- Filling the detergent and additives
- Setting a programme
- Starting a programme
- Starting a programme with the delay start
- The AutoAdjust System load detection
- Pausing a programme and changing options
- Cancelling a running programme
- Opening the door
- End of the programme
- Draining water out after end of cycle
- Stand-by function
- Hints and tips
- Care and cleaning
- Troubleshooting
- Consumption values
• - The mains supply is unstable. Wait until the mains supply is stable.
• - No communication between electronic elements of the appliance. Switch it o and
switch on again. The programme was not nished properly or the appliance stopped too
early. If the alarm code appears again, contact the Authorised Service Centre.
• - The appliance does not ll with water properly. After the proper check, start the
appliance again by pressing Start/Pause button the appliance tries to resume the
cycle . If the error persists the alarm code will appear again.
•
- The appliance does not drain the water.
•
- The appliance door is open or not closed correctly. Please check the door!
If the appliance is overloaded, remove some items from the drum and/or hold
the door shut while touching the Start/Pause button until the indicator
stops ashing (see the picture below).
Possible failures
Problem Possible solution
The programme does not
start.
• Make sure that the mains plug is connected to the mains
socket.
• Make sure that the appliance door is closed.
• Make sure that there is no damaged fuse in the fuse box.
• Make sure that the Start/Pause has been touched.
• If the delay start is set, cancel the setting or wait for the end
of countdown.
• Deactivate the Child Lock function if it is on.
• Check the position of the knob on the selected programme.
The appliance does not
ll with water properly.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the inlet hose has no kinks, damages or
bends.
• Make sure that the connection of the water inlet hose is cor‐
rect.
• Make sure that the lter of the inlet hose and the lter of the
valve are not clogged. Refer to 'Care and cleaning'.
ENGLISH 31