- IkeLite Indoor Lighting

13
non-Ikelite Housing Front
d
eflector
hook material
port
non-Ikelite Housing Front
flash
d
iffuser
port
non-Ikelite Housing Front
d
eflector material
c
ut-out
deflector material
cut-out
p
ort
CCoonnnneeccttiinngg AAFF3355 HHaannddllee ttoo TTrraayy
((ssiinnggllee oorr dduuaall))
The base of the Handle that slides over the tray mount has a nylon
screw. Note that the tray has a notch for the nylon screw to fit into
when the handle is mounted to the tray and the nylon screw is
screwed down. Back the screw out far enough to slide the handle
base onto the tray mount. Align the handle mount with the tray
mount as shown, push the handle mount onto the tray mount and
secure with nylon screw. Reverse this procedure to remove the
handle.
nylon screw
handle mount
secure handle to
tray with nylon screw
locking groove
tray mount
14
15
FFlleexx AArrmm
The AF35 Flex Arm is quite versatile, it allows the flash head to be
placed in many different positions for optimal lighting. The flash
head is connected to the sensor with a sync cord that runs through
the center of the flex arm. If the flex arm is bent too far it may
separate from the top bead on the sensor body. The flex arm and
flash will still be connected to the sensor and handle by the sync
cord,
DDOO NNOOTT
put undue force on the sync cord. If the Flex Arm
separates from the top of the sensor, position the bottom bead of
the Flex Arm over the bead on the top of the sensor body and push
down to reinstall. The flex arm should snap back into position.
align arm
beads
push
down to
rejoin
16
LLuubbrriiccaanntt
• Use only Ikelite brand silicone lubricant with Ikelite brand o-rings;
other brand lubricants can cause the Ikelite o-rings to swell in size.
• Do Not use spray lubricant; it can crack the plastic parts of the Kit.
• Lubricant reduces friction and prolongs the life of o-rings, it is not a
sealant. Use only enough lubricant to lightly cover the area being
applied; wipe off any excess with a clean cloth.
MMaaiinntteennaannccee
Your Ikelite AF35 AutoFlash Kit should be given the same care and
attention as your other photographic equipment.
Routine Cleaning
Caution: Make sure the AF35’s battery door is on and tightened
down before exposing the flash to water. Ideally, water should never
enter the battery compartment. If this does occur, see “Battery
Compartment Flooding” on page 17.
1. Always rinse the exterior of the AF35 with fresh water after use,
especially after exposure to salt water. While rinsing, turn the
mode switch to free salt or debris that might have accumulated in
recesses during the dive.
2. Dry the AF35 thoroughly.
LLoonngg TTeerrmm SSttoorraaggee
1. Make sure the battery door is on and tightened down firmly.
2. Soak the Kit in a mild soap solution, operate the mode switch to
free salt or debris, rinse and dry before storage.
3. When storing the Kit, remove the batteries from the flash. Lightly
lubricate the exposed part of the door’s o-ring and store the AF35
flash with the battery door lightly screwed on, this will allow any
hydrogen/air mixture to escape the battery compartment and
avoid unnecessary pressure on the o-ring that could cause it to
flatten.